Off center fed multiband antenna for 80 - 40 - 20 - 10 meter bands with frequency ranges of 3500kHz to 3800kHz, 7000kHz to 7200kHz, 14000kHz to 14350kHz, and 28000kHz to 29700kHz with overall length of 41.5 meters (~ 136 ft.) (arms length: 27.7m/ ~91ft., 13.8m/ ~45ft.), with 0dBd gain on 80m band. A maximum power load of 300W PEP SSB with the 6:1 ratio balun
|Frequency range||3500 Khz – 3800 Khz, 7000 Khz – 7200 Khz, 14000 Khz – 14350 Khz a 28000 Khz – 29700 Khz|
|Working band of the antenna||Approx.100 kHz for SWR less than 2 (depends on the placement of the antenna in space)|
|Arms length||27.7m/ ~91ft., 13.8m/ ~45ft.|
|Overall length||41.5 meters (~ 136 ft.)|
|Gain||0 dBd for the 80 meter band|
|Maximum power load||300W PEP SSB|
|Antenna feed||50 ohm coaxial cable|
|Mounting height||not less than 14 meters (~45 feet) (the higher, the better)|
The materials used to build this antenna have been selected with an emphasis on the best electrical and mechanical properties, and resistance against outside weather conditions. An equally important factor is the durability of these properties in the future.
For the dipole arms a hardened and prestressed copper line with a cross-section of 2,5sqmm and a harder PVC isolation is used.
On the box side of the dipole arm the wire is ended with a wire eye for a M4 screw, made by ZES Dolny Kubin.
It is isolated by a shrink tube on both sides. The mechanical connection with the balun is made with a simple wire loop secured with a duplex wire clamp and, on the hanging rope side, a ceramic isolator (type 16C01 made by MFJ is used), also secured with a duplex wire clamp.
The antenna balun with a ratio of 6:1 and a maximum power rating of 300W PEP SSB is made from a waterproof box of IP56 made by SCAME, model 686.205.
On both sides of the box are screws with closed hook ends; the screws are of size M5, made from anticorrosion steel for long time lasting loads.
A more solidly made SO239 connector is used, with DAP diaelectricum, bolted to the box via anticorrosion steel screws and nuts.
The balun transformer is wound on a ferite toroid core model AMR R1 with the respective measurments of (outer x inner x height) 36 x 23 x 15 mm.
The arms of the dipole are electrically connected to the transformer through a pair of M4 bolts and nuts on both sides of the box.
The connector on the antenna serves only to electrically connect with the coaxial cable. For bearing the coaxial cable, use the attached rope. (with inner core made by LANEX).
After the antenna is tuned, it is required to insulate the ends of the arms with shrink tubing to prevent water intrusion.
The warranty does not cover damage made by overloading the balun with more power than specified on the balun`s label.